The diagram below shows how geothermal energy is used to produce electricity.
The diagram depicts how
electricity
is generated in a geothermal power station.
Overall
, there are five main steps in order to produce electricity
: pumping down cold water
underground, injecting water
through well injections, pumping hot water
to the surface of the ground, using steam to run the turbine and finally
, passing the generated electricity
to the electrical masts.
Firstly
, the cold water
stored in the case is pumped to 4.5 km beneath the earth. Then
it will be injected into the injection well and subsequently
, runs through hot rocks in the geothermal zone. Thus
, the water
will be heated. Moreover
, when the water
has become hot, it will be pumped up through a production well.
Afterwards, the heated water
will be converted to steam in a condenser. After that, the produced steam will drive the blades of the turbine to power the generator so electricity
is generated and then
, will be sent to the electrical masts.Submitted by mohammadmgh1381 on
Unauthorized use and/or duplication of this material without express and written permission from this site’s author and/or owner is strictly prohibited. Excerpts and links may be used, provided that full and clear credit is given to Writing9 with appropriate and specific direction to the original content.
Basic structure: Change the third paragraph.
▼
Basic structure: Change the fourth paragraph.
▼
Vocabulary: Replace the words electricity, water with synonyms.
▼
Vocabulary: Rephrase the word "undefined" in your introduction.
▼
Vocabulary: Only 2 basic words for charts were used.
▼
Vocabulary: Use several vocabularies to present the data in the second paragraph.
▼
Vocabulary: Use several vocabularies to present the data in the third paragraph.
▼
Vocabulary: Use several vocabularies to present the data in the fourth paragraph.
▼