The diagram shows the process of coloured plastic quality control. Summarize the information by selecting and reporting the main features, and make comparisons where relevant.
The given flowchart illustrates the procedure of limiting the
quality
of coloured plastic
.
Overall
, it can be observed that the process is primarily divided into three parts starting with molten plastic
and finishing with packing and dispatch.
Firstly
, molten plastic
is separated into three separate moulds named
red mould, blue mould, and yellow mould. In the upcoming step, all three moulds will be sent for Verb problem
apply
quality
control where a machine checks for strength. Further
, it is rejected if the quality
is not matched.
However
, if the standard is accepted then
it will be sorted by hand before the further
steps. Plastic
which is of the same colour is detached differently and the plastic
which is of multiple colours is separated before going to the next step. In the subsequent step, again the quality
of the plastic
is measured to check for mixture and singles. In the final phase, it is packaged and dispatched.Submitted by vishank.chauhan19504 on
Unauthorized use and/or duplication of this material without express and written permission from this site’s author and/or owner is strictly prohibited. Excerpts and links may be used, provided that full and clear credit is given to Writing9 with appropriate and specific direction to the original content.
Linking words: Don't use the same linking words: "further".
▼
Introduction: The introduction is missing.
▼
Introduction: The chart intro is missing.
▼
Basic structure: Change the third paragraph.
▼
Introduction: The chart intro is missing.
▼
Vocabulary: Replace the words quality, plastic with synonyms.
▼
Vocabulary: Only 4 basic words for charts were used.
▼
Vocabulary: Use several vocabularies to present the data in the third paragraph.
▼