The diagram below shows how geothermal energy is used to produce electricity
The picture reveals
the
information about the process of making Correct article usage
apply
electricity
in a geothermal power plant.
In general, what stands out from the diagram is that there are 5 stages in the production of electricity
. The process starts with cold water
being pumped down the injection well and ends when electricity
is produced and transmitted to the national grid.
As mentioned earlier, in the beginning, cold water
is pumped down the injection well and keeps moving through a geothermal zone of hot rocks where water
gets heated. In the stage after
this
, hot water
is transferred to the production well and being
pumped up to a condenser which converts hot Unnecessary verb
apply
water
into steam. Following that, the steam creates power
to make the turbine spin. It can be seen from the picture that the spinning of the turbine powers the generator which is Add an article
the power
also
the place where electricity
is produced. Eventually, the process ends when produced electricity
leaves the geothermal power plant for the national grid.Submitted by Mai Hoàng on
Unauthorized use and/or duplication of this material without express and written permission from this site’s author and/or owner is strictly prohibited. Excerpts and links may be used, provided that full and clear credit is given to Writing9 with appropriate and specific direction to the original content.
Introduction: The introduction is missing.
▼
Introduction: Change the first sentence in the introduction.
▼
Introduction: The chart intro is missing.
▼
Basic structure: Change the third paragraph.
▼
Introduction: The chart intro is missing.
▼
Vocabulary: Replace the words electricity, water with synonyms.
▼
Vocabulary: Only 4 basic words for charts were used.
▼
Vocabulary: Use several vocabularies to present the data in the third paragraph.
▼